Replacement of a damaged camera Cable

To change a damaged Primescan camera cable you need at first the repair set with the new cable. Also you can find in this set a special key. The first step is, to remove the cover screw in the back of the camera. After removing the cover you must loosen two screws of the strain relief with a Torx no. 6 screwdriver. After removing the silver inner cover, it it possible to loosen the plug of the cable. Now you can install the new cable. The silvery cover should be replaced with a new one, wich is contained in the repair set. Also in this set its a new foil to cover the small gap around the cover. Then fix the 2 screws and close the housing of the camera. At least attach the cover crew with the special key and the repair is finished.