Rating
0
3D PRINTED BITE SPLINTS - Part 2: Particularities while scanning for splints
The scanning should be done with the CONNECT software in consideration of some special things.
SCANNING FOR SPLINTS
- Use the CONNECT software
- Scan with the POLL-technique
(guided scan for Omnicam)
- Special attention for interproximal aeras
- Scan lingual areas completely
- Also retromolar areas are importatnt
- Clear lateralscan from both sides
Difficulty level:
Beginner |Advanced
Beginner |Advanced
Author:
DR. ANDREAS KURBAD
DR. ANDREAS KURBAD
Creation date:
25.06.2022
25.06.2022
Lenght:
09:14 Min.
09:14 Min.
Software:
CONNECT 5.2.3 Min.
CONNECT 5.2.3 Min.